Tele-vue Tele-Pod Tripod Bedienungsanleitung PDF herunterladen

32 Elkay Dr., Chester, NY 10918 (845) 469-4551 www.televue.com

Tele Vue

Visionary

TELE-POD TRIPOD INSTRUCTIONS

PARTS LIST

Tele-Pod Tripod (TPT-2017)

Allen Keys: (1) 3mm, and (2) 4mm

INTRODUCTION

Thank you for purchasing the Tele-Pod Tripod. This lightweight, aluminum tripod

can be used with 3/8-16 or 1/4-20 camera heads or our Tele-Pod head.

COMPONENTS

The Tele-Pod tripod consists of the tripod legs, an extending center column

with a reversible 3/8-16 or 1/4-20 thread adapter. See separate instruction

sheet for more features of the tripod.

SET-UP

Head installation on 3/8-16 stud.

1) Extend each tripod leg so that the quick-release plate is approximately level.

2) To install your camera head or telescope head on the 3/8-16 stud, simply

thread it on until it is tight.

3) Loosen the Height Adjustment Lock Knob and raise the center column a

few inches. Lock the center column.

4) Using the 3mm Allen Key, tighten the three Set Screws on the bottom of the

tripod ﬂange to lock your head.

USE

WARNING: If setting a up on a slope, ensure that the tripod legs are extended

so that the head is approximately level with the horizon. Use the bubble level

on the tripod for reference. Failure to due so could cause the telescope to tip

over! This risk increases when using larger, longer scopes.

Extend each tripod leg by loosening the Leg Clamps and tightening at the

desired height. Make sure the bubble is approximately in the center of the level.

Height Adjustment

Lock Knob

3/8-16 Thread

Set-Screws

Tripod Flange Bottom

32 Elkay Dr., Chester, NY 10918 (845) 469-4551 www.televue.comTele VueVisionaryTELE-POD TRIPOD INSTRUCTIONSPARTS LISTTele-Pod Tripod (TPT-2017)Alle

Keine Kommentare

Tele-vue Tele-Pod Tripod Bedienungsanleitung